bizTech Software : Development Blog: Cleaning Cyberview Scanner

Scanner Cleaning

Perform the following cleaning procedure periodically every week, whenever black lines appear on the scanned image or scanning errors occur.
1. Grab the Scanner Cover by the tips of the input and output guides, or alternatively, by the Front and Back borders on each side.

Grab

2. Either use one or two hands
i.

Grab

3. Lift-up the Scanner Cover.

Lift-Up

Lift-Up

4. Place the Scanner Cover away from the scanner.

5. Locate the two Feed Roller Lock-Levers as shown (only right side shown).

Right Side Lock-Lever

Feed Roller

6. Place both thumbs on the Feed Roller Lock-Levers grooves and push-backward to rotate them.

Rotate Backward

7. Rotate the two Lever-Locks until the Lever-Tail is oriented upward (only right side shown).
i.

Lock-Tail oriented upward

ii.

8. The Feed-Roller will be released when the 2 Lock-Tails are in the upward position
9. Grab-up both Lock-Tails.
i.

Grab-up

ii.

Grab-up

10. Lift the Feed Roller straight up by holding the two Lock-Tails.
i.

Lift straight up

ii.

Lift-up

11. Take-away the Feed Roller.

Take-away

12. The Glass of the Image Sensor will swing up and be fully exposed.
13. Open a new Cleaning Wipe bag provided and gently swipe the impregnated wipe over the entire glass surface from side to side.
i.

Swipe

Glass

14. Examine closely the surface of the Image Sensor Glass for cleanliness and rub with a fingernail on difficult-to-remove spots.
15. Put-back the Feed Roller by holding the Lock-Levers Handles vertically, then engaging them into their slots. Ensure the toothed gear wheels mesh correctly.

Put-back in

16. Once engaged in their slots, turn the Lever-Locks toward the front.
i.

Turn toward Front

ii.

17. Pushdown the two Lever-Tails until they reach the horizontal position.

Push-down

18. The two Lever-Tails should be pushed-down toward the front; otherwise, the Feed Roller will pop off during operation of the scanner.
19. Replace the Scanner Cover.
i.

Push-down